Area Default-Cost (Router Ospf) - Dell PowerEdge M420 Reference Manual

area range (Router
OSPF)
area stub
area stub no-
summary
area virtual-link
area virtual-link
authentication
area virtual-link
dead-interval
area virtual-link
hello-interval
area virtual-link
retransmit-interval
area virtual-link
transmit-delay
auto-cost

area default-cost (Router OSPF)

Use the area default-cost command in Router OSPF Configuration mode to
configure the advertised default cost for the stub area. Use the no form of the
command to return the cost to the default value.
Syntax
area-id
area default-cost
area-id
no area default-cost
area-id — Identifies the OSPF stub area to configure. (Range: IP address
•
or decimal from 0-4294967295)
integer — The default cost for the stub area. (Range: 1–16777215)
•
distribute-list out
enable
exit-overflow-
interval
external-lsdb-limit passive-interface
ip ospf area
ip ospf
authentication
ip ospf cost
ip ospf dead-
interval
ip ospf hello-
interval
ip ospf mtu-ignore show ip ospf abr
integer
nsf helper
nsf helper strict-
lsa-checking
nsf restart-interval show ip ospf statistics
default
passive-interface
redistribute
router-id
router ospf
show ip ospf
OSPF Commands
show ip ospf neighbor
show ip ospf range
show ip ospf stub table
show ip ospf virtual-
link
show ip ospf virtual-
links brief
timers spf
1069