Dell PowerEdge M420 Reference Manual page 615

Syntax
match class-map
no match class-map
refclassname — The name of an existing DiffServ class whose match
•
conditions are being referenced by the specified class definition.
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
• The parameters
• Only one other class may be referenced by a class.
• Any attempts to delete the
referenced by any
• The combined match criteria of
be an allowed combination based on the class type.
• Any subsequent changes to the
maintain this validity, or the change attempt fails.
• The total number of class rules formed by the complete reference class
chain (including both predecessor and successor classes) must not exceed
a platform-specific maximum. In some cases, each removal of a refclass
rule reduces the maximum number of available rules in the class definition
by one.
Example
The following example adds match conditions defined for the Dell class to
the class currently being configured.
console(config-classmap)#match class-map Dell
The following example deletes the match conditions defined for the Dell
class from the class currently being configured.
refclassname
refclassname
refclassname and class-map-name can not be the same.
refclassname class while the class is still
class-map-name fails.
class-map-name and refclassname must
refclassname class match criteria must
QoS Commands
615