Link-Dependency Group - Dell PowerEdge M420 Reference Manual

Default Configuration
The default configuration for a group is down, i.e. the group members will
mirror the depended-on link status by going down when all depended-on
interfaces are down.
Command Mode
Link Dependency mode
User Guidelines
The action up command will cause the group members to be up when no
depended-on interfaces are up.
Example
console(config-depend-1)#action up

link-dependency group

Use the link-dependency group command to enter the link-dependency
mode to configure a link-dependency group
Syntax
GroupId
link-dependency group
GroupId
no link-dependency group
GroupId — Link dependency group identifier. (Range: 1–72)
•
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
The preference of a group is to remain in the up state. A group will be in the
up state if any depends-on interface is up and will be in the down state only if
all depends-on interfaces are down.
526
Link Dependency Commands