Show Ipv6 Ospf Border-Routers; Show Ipv6 Ospf Database - Dell PowerEdge M420 Reference Manual

INTRA 4.4.4.4

show ipv6 ospf border-routers

Use the show ipv6 ospf command to display internal OSPFv3 routes to reach
Area Border Routers (ABR) and Autonomous System Boundary Routers
(ASBR). This command takes no options.
Syntax
show ipv6 ospf border-routers
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC mode.

show ipv6 ospf database

Use the show ipv6 ospf database command in Privileged EXEC mode to
display information about the link state database when OSPFv3 is enabled. If
no parameters are entered, the command displays the LSA headers. Optional
parameters specify the type of link state advertisements to display.
The information below is only displayed if OSPF is enabled.
Syntax
show ipv6 ospf [
link | network | nssaexternal | prefix | router | unknown [area | as | link]}]
link-state-id
[ ] [adv-router [
area-id — Identifies a specific OSPF area for which link state database
•
information will be displayed.
• external — Displays the external LSAs.
• inter-area — Displays the inter-area LSAs.
• link — Displays the link LSAs.
• network — Displays the network LSAs.
10 0.0.0.1
area-id
] database [{external | inter-area {prefix | router} |
router-id
FE80::210:18FF:FE82:8E1
] | self-originate]
OSPFv3 Commands
vlan12
1187