Ip Pim Dense - Dell PowerEdge M420 Reference Manual

Syntax
ip pim bsr-candidate vlan {
no ip pim bsr-candidate vlan {
Parameter Description
Parameter
vlan-id
hash-mask-length
bsr-priority
Default Configuration
None - the router does not advertise itself as a BSR candidate.
Command Mode
Global Configuration mode
User Guidelines
All multicast groups with the same hash value correspond to the same RP .
Lower priority values are preferred.
Example
console(config)#ip pim bsr-candidate vlan 10 16 0

ip pim dense

Use the ip pim dense command in Global Configuration mode to
administratively configure PIM dense mode for IP multicast routing. Use the
no form of this command to disable PIM dense mode. This command
replaces the ip pimsm command.
Syntax
ip pim dense
1024
Multicast Commands
vlan-id hash-mask-length bsr-priority
vlan-id}
Description
A valid VLAN identifier with multicast routing enabled.
Length of the BSR hash to be
group address. (Range 0–32 bits). Default 0.
The advertised priority of the BSR candidate. Range 0-255.
Default 0.
ANDed with the multicast
}