Dell PowerEdge M420 Reference Manual page 1117

Number of Active
Areas
ABR Status
ASBR Status
Stub Router
External LSDB
Overflow
External LSA
Count
External LSA
Checksum
AS_OPAQUE LSA
Count
AS_OPAQUE LSA
Checksum
New LSAs
Originated
LSAs Received
LSA Count
Maximum Number
of LSAs
The number of OSPF areas to which the router is attached on
interfaces that are up.
Shows whether the router is an OSPF Area Border Router.
Indicates whether the router is an autonomous system border
router. Router automatically becomes an ASBR when it is
configured to redistribute routes learned from another protocol.
The possible values for the ASBR status is enabled (if the router
is configured to re-distribute routes learned by other protocols)
or disabled (if the router is not configured for the same).
OSPF enters stub router mode, as described in RFC 3137, when
it encounters a resource limitation that prevents it from
computing a complete routing table. In this state, OSPF sets the
link metrics of non-stub links in its own router LSAs to the
largest possible value, discouraging other routers from
computing paths through the stub router, but allowing other
routers to compute routes to destinations attached to the stub
router. To restore OSPF to normal operation, resolve the
condition that caused the resource overload, then disable and re-
enable OSPF globally.
OSPF enters this state when the number of external LSAs
exceeds a configured limit, as described in RFC 1765.
Shows the number of external (LS type 5) link-state
advertisements in the link-state database.
Shows the sum of the LS checksums of external link-state
advertisements contained in the link-state database.
Shows the number of AS Opaque LSAs received.
Sum of the checksums of all AS Opaque LSAs in the link state
database.
Shows the number of link-state advertisements that have been
originated.
Shows the number of link-state advertisements received
determined to be new instantiations.
The number of LSAs in the link state database.
The limit on the number of LSAs that the router can store in its
link state database.
OSPF Commands
1117