Distribute-List Out - Dell PowerEdge M420 Reference Manual

Dell powerconnect m6220/m6348/m8024/m8024-k cli reference guide
Hide thumbs Also See for PowerEdge M420:
Table of Contents

Advertisement

Parameter
inter-area dist2
external dist3
Default Configuration
The default preference value is 110 for dist1, dist2 and dist3.
Command Mode
Router OSPF Configuration mode.
Router OSPFv3 Configuration mode.
User Guidelines
There are no user guidelines for this command.
Examples
The following examples set route preference values of OSPF in the router.
console(config-router)#distance ospf intra 4
console(config-router)#distance ospf type1 19

distribute-list out

Use the distribute-list out command in Router OSPF Configuration mode to
specify the access list to filter routes received from the source protocol. Use
the no form of the command to remove the specified source protocol from
the access list.
Syntax
name
distribute-list
no distribute-list
Description
Used to select the best path from one area to another area when
there are two or more routes to the same destination from two
different routing protocols (Range: 1–255).
Used to select the best path for routes from other routing
domains, learned by redistribution when there are two or more
routes to the same destination from two different routing
protocols (Range: 1–255).
out {rip | static
name
out {rip | static
\
connected}
\
connected}
OSPF Commands
1093

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents