Service Dhcp; Sntp - Dell PowerEdge M420 Reference Manual

Dell powerconnect m6220/m6348/m8024/m8024-k cli reference guide
Hide thumbs Also See for PowerEdge M420:
Table of Contents

Advertisement

Example
console(config-dhcp-pool)#option 4 ascii
"ntpservice.com
"
console(config-dhcp-pool)#option 42 ip 192.168.21.1
console(config-dhcp-pool)#option 29 hex 01
console(config-dhcp-pool)#option 59 hex 00 00 10 01
console(config-dhcp-pool)#option 25 hex 01 ff

service dhcp

Use the service dhcp command in Global Configuration mode to enable local
IPv4 DHCP server on the switch. Use the no form of the command to disable
the DHCPv4 service.
Syntax
service dhcp
no service dhcp
Default Configuration
The service is disabled by default.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.

sntp

Use the sntp command in DHCP Pool Configuration mode to set the IPv4
address of the NTP server to be used for time synchronization of the client.
Use the no form of the command to remove the NTP server configuration.
836
DHCP Server and Relay Agent Commands

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents