Exit-Overflow-Interval; External-Lsdb-Limit - Dell PowerEdge M420 Reference Manual

exit-overflow-interval

Use the exit-overflow-interval command in Router OSPFv3 Configuration
mode to configure the exit overflow interval for OSPF. It describes the
number of seconds after entering Overflow state that a router will wait before
attempting to leave the Overflow State. This allows the router to originate
non-default AS-external-LSAs again. When set to 0, the router will not leave
Overflow State until restarted.
Syntax
seconds
exit-overflow-interval
no exit-overflow-interval
seconds — Exit overflow interval for OSPF (Range: 0-2147483647)
•
Default Configuration
seconds
0 is the default value for .
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the exit overflow interval for OSPF at 100
seconds.
console(config)#ipv6 router ospf
console(config-rtr)#exit-overflow-interval 100

external-lsdb-limit

Use the external-lsdb-limit command in Router OSPFv3 Configuration
mode to configure the external LSDB limit for OSPF. If the value is -1, then
there is no limit. When the number of non-default AS-external-LSAs in a
router's link-state database reaches the external LSDB limit, the router enters
1163
OSPFv3 Commands