Spanning-Tree Transmit Hold-Count - Dell PowerEdge M420 Reference Manual

Default Configuration
TCN propagation is disabled by default.
Command Mode
Interface Configuration (Ethernet, Port Channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures spanning-tree tcnguard on 4/0/1.
console(config-if-4/0/1)#spanning-tree tcnguard

spanning-tree transmit hold-count

Use the spanning-tree transmit hold-count command to set the maximum
number of BPDUs that a bridge is allowed to send within a hello time window
(2 seconds). Use the no form of this command to reset the hold count to the
default value.
Syntax
value
spanning-tree transmit [hold-count] [ ]
no spanning-tree transmit hold-count
value — The maximum number of BPDUs to send (Range: 1–10).
•
Default Configuration
The default hold count is 6 BPDUs.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
707
Spanning Tree Commands