GE Senographe DS Manual page 1718

GE Healthcare
Revision 1
Job Card CAL A049 - Compression Paddle Offset Calibration
A list of paddle offets similar to the following appears.
---------------------------------------------------
No - Paddle
---------------------------------------------------
1 - Phlex 19x23
2 - Std 19x23
3 - Auxiliary
4 - Round spot
5 - Square spot
6 - Biopsy
7 - Spot biopsy
11 - High wall
12 - Std mag stand
14 - Round mag stand
15 - Square mag stand
16 - Phlex 19x23 sliding 0
17 - Std 19x23 sliding
18 - Round spot sliding
19 - Square spot sliding -3
20 - Biopsy sliding
21 - Spot biopsy sliding 0
22 - Std 24x30
23 - Phlex 24x30
4. If any of the final offset values are not as expected, repeat procedure from step
Determine the Current Offset for Each of the Compression Paddles on page 1717
Compression Paddle(s).
5. For each Compression Paddle you changed the offset for, follow these steps:
a. Insert the compression Paddle.
b. Apply a compresison of 10 dAN.
c. Verify the Gantry LCD Readout displays exactly the known thickness of the 40 mm acrylic plate,
as measured in step
Paddles on page
If the LCD readout does not display exactly the known thickness of the 40 mm acrylic plate,
repeat the calibration procedure starting from step
for Each of the Compression Paddles on page
6. If all of the offset values are as expected, exit the telnet connection with the Gantry CPU Board, by
entering:
logout
Chapter 9
Service Information and Procedures Class A 2385072-16-8EN
Deformation Offset (1/10th mm))
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
2 of Section 7-2 Determine the Current Offset for Each of the Compression
1717.
2 of Section
1717.
Page no. 1718
Senographe DS
2 of Section
for the appropriate
7-2 Determine the Current Offset
7-2
JC-CAL-A-049.fm