GE Senographe DS Manual page 1770

Task Title
Gantry:
Remove Gantry covers.
Check Breast Thickness Measurement
Check Gantry functions
Check for correct collimation
Check and lubricate Gantry mechanisms
Reinstall Gantry covers
Check Manual Compression maximum
force.
Check Gantry emergency stop buttons.
Control Station
Check UPS function
Recalibrate UPS Battery Capacity
Remove Control Station covers
Change AWS (U20) Motherboard battery
(V3 Control Stations only)
Clean IDC air filter (only applicable on sys-
tems with the Dione 5 IDC)
Reinstall Control Station covers
Task Definition
Job Card PHY A044 - Remove/Reinstall Gantry
Covers: p. 523
Job Card ELE A015 - Gantry Functional Checks
section 6-9 Check Breast Thickness Measure-
ment: p. 581
Job Card PM A201 - Gantry operational checks:
p. 1777
Job Card ELE A028 - Collimation Checks: p. 679
Job Card PM A205 - Mechanical checks and lubri-
cation: p. 1779
Job Card PHY A044 - Remove/Reinstall Gantry
Covers: p. 523
Job Card ELE A017 - Manual Compression
Check and Calibration: p. 583
Check operation of both Gantry emergency stop
buttons. Check that all movement of the Ganttry is
stopped when either button is pressed.
Job Card CHK A003 - UPS Batteries section 6
UPS Function Check: p. 1737
Job Card CHK A003 - UPS Batteries section 7
Battery Capacity Re-Calibration: p. 1738
Job Card PHY A040 - Remove/Reinstall Control
Station Covers on page 503
Job Card D/R A335 - AWS (U20) Motherboard
Battery (V3 Control Stations only) on page 1537
Job Card PM A425 - IDC Air Filter Cleaning on
page 1803
Job Card PHY A040 - Remove/Reinstall Control
Station Covers on page 503
Int. Drn. PM Visit no.
mth. min. 1 2 3
12 20 X X
- 6 10 X X X
12 10 X X
12 20 X X
12 20 X X
12 30 X X
12 10 X X
12 5 X X
6 5 X X X
12 10 X X
6 10 X X X
12 15 X
6 10 X X X
6 10 X X X
4 5 6
X
X X X
X
X
X
X
X
X
X X X
X
X X X
X X
X X X
X X X