Note:
(Hold) to switch between Pause and Restart for the monitor display. The "Hold (ENTER)" message flashes while you pause
Push
monitoring.
◆
Change Parameter Settings
This example shows how to change the setting value for C1-01 [Acceleration Time 1]. Do the steps in this procedure
to set parameters for the application.
1.
Push
(Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If [Home] is not shown above the
2.
Push
(Menu).
3.
Push
or
4.
Push
or
5.
Push
or
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
, push
(Back).
to select [Parameters], then push
to select [C Tuning], then push
to select [C1 Accel & Decel Time], then push
.
.
.
3.6 Keypad Operation
535
3