O2: Keypad Operation - YASKAWA HV600 Manual

2.11 o: Keypad-Related Settings
◆

o2: Keypad Operation

■
o2-02: OFF Key Function Selection
No.
Name
(Hex.)
o2-02 OFF Key Function Selection
(0506)
0 : Disabled
1 : Enabled
stays enabled when the Run command source is not assigned to the keypad.
To start the drive again after you push
■
o2-03: User Parameter Default Value
No.
Name
(Hex.)
o2-03 User Parameter Default
Value
(0507)
When you set o2-03 = 1 [Set defaults], the drive saves changed parameter settings as user parameter setting values in
a part of the memory that is isolated from drive parameters.
When you set A1-03 = 1110 [Initialize Parameters = User Initialization] to initialize the drive, the drive resets the
internal parameter setting values to those user parameter setting values.
0 : No change
1 : Set defaults
Saves changed parameter setting values as user default settings.
Set o2-03 = 1 then push
automatically resets to 0.
2 : Clear all
Deletes all of the saved user parameter setting values.
Set o2-03 = 2 then push
you delete the user parameter setting values, you cannot set A1-03 = 1110 to initialize parameters.
■
o2-04: Drive Model (KVA) Selection
No.
Name
(Hex.)
o2-04 Drive Model (KVA)
Selection
(0508)
NOTICE: Set o2-04 [Drive Model Selection] correctly. If you set this parameter incorrectly, it will decrease drive performance, cause
the protection function to operate incorrectly, and cause damage to the drive.
Note:
When the setting value of o2-04 changes, related parameter setting values also change. Refer to
Selection] on page 152 for more information.
These tables list the relation between o2-04 setting values and drive models.
o2-04 Setting
65
67
416
V/f OLV/PM EZOLV OLV/PM
Sets the function to use
the drive is REMOTE (external) and not assigned to the keypad.
to stop operation, turn the external Run command OFF and ON again.
V/f OLV/PM OLV/PM EZOLV
Sets the function to keep the settings of changed parameters as user parameter defaults to use during
initialization.
to save the user parameter setting values. After the drive saves the setting value, o2-03
to clear the user parameter setting values. The drive will automatically reset o2-03 to 0. If
V/f OLV/PM EZOLV OLV/PM
Sets the Drive Model code. Set this parameter after you replace the control board.
Drive Model
2011
2017
Description
on the keypad to stop the drive when the Run command source for
Description
Description
o2-04 Setting
68
6A
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
Default
(Range)
Default
(Range)
Default
(Range)
Determined by the drive
Defaults by o2-04 [Drive Model (kVA)
Drive Model
2024
2031
1
(0, 1)
0
(0 - 2)
(-)