T: Auto-Tuning; T0: Tuning Mode Selection; T1: Induction Motor Auto-Tuning - YASKAWA HV600 Manual

2.13 T: Auto-Tuning

2.13

T: Auto-Tuning

T parameters set input data for:
• Induction Motor Auto-Tuning
• PM Motor Auto-Tuning
◆

T0: Tuning Mode Selection

■
T0-00: Tuning Mode Selection
No.
Name
(Hex.)
T0-00 Tuning Mode Selection
(1197)
0 : Motor Parameter Tuning
Note:
The available tuning modes are different for different control methods.
◆

T1: Induction Motor Auto-Tuning

T1 parameters set the Auto-Tuning input data for induction motor tuning.
Note:
• The base frequency of drive-dedicated motors and special vector-control motors can be lower than the base frequency of general-purpose
motors, which is 50 Hz or 60 Hz. In these conditions, the drive uses the lower frequency as the value for E1-06 [Base Frequency] and E1-
04 [Maximum Output Frequency] after Auto-Tuning completes. If the maximum output frequency is too low and causes problems, change
the setting of E1-04 after Auto-Tuning completes.
• The drive automatically sets these induction motor parameters:
–E1-xx [V/f Pattern for Motor 1]
–E2-xx [Motor Parameters]
–E3-xx [V/f Pattern for Motor 2]
–E4-xx [Motor 2 Parameters]
■
T1-00: Motor 1/Motor 2 Selection
No.
Name
(Hex.)
T1-00 Motor 1/Motor 2 Selection
(0700)
Note:
This parameter is available when H1-xx = 16 [Motor 2 Selection]. The keypad will not show this parameter when H1-xx ≠ 16.
1 : Motor 1 (sets E1-xx, E2-xx)
Auto-Tuning automatically sets parameters E1-xx and E2-xx for motor 1.
2 : Motor 2 (sets E3-xx, E4-xx)
Auto-Tuning automatically sets parameters E3-xx and E4-xx for motor 2. Make sure that you connect motor 2 to the
drive for Auto-Tuning.
■
T1-01: Auto-Tuning Mode Selection
No.
Name
(Hex.)
T1-01 Auto-Tuning Mode Selection
(0701)
0 : Rotational Auto-Tuning
2 : Stationary Line-Line Resistance
460
V/f OLV/PM EZOLV OLV/PM
Sets the type of Auto-Tuning.
V/f OLV/PM EZOLV OLV/PM
Sets which motor to tune when motor 1/2 switching is enabled.
V/f OLV/PM EZOLV OLV/PM
Sets the type of Auto-Tuning.
Description
Description
Description
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
Default
(Range)
0
(0)
Default
(Range)
1
(1, 2)
Default
(Range)
0
(0, 2)