YASKAWA HV600 Manual page 456

2.12 S: Special Applications
11 : m: meters
12 : ft: feet
13 : L/min: liters/min
3
14 : m /min: cubic meters/min
15 : "Hg: Inch Mercury
16 : kPa: kilopascal
48 : %: Percent
49 : Custom(b5-68~70)
50 : None
■
S6-05: EMOVR Independent PID Unit Digit
No.
Name
(Hex.)
S6-05 EMOVR Independent PID
Unit Digit
(323C)
0 : No Decimal Places (XXXXX)
1 : One Decimal Places (XXXX.X)
2 : Two Decimal Places (XXX.XX)
3 : Three Decimal Places (XX.XXX)
■
S6-06: EMOVR PID Setpoint
No.
Name
(Hex.)
S6-06 EMOVR PID Setpoint
(323D)
RUN
Note:
When S6-02 = 3: units and resolution are dependent on S6-04 [EMOVR Independent PID Unit] and S6-05 [EMOVR Independent PID Unit
Digit]. Value is internally limited to 300% of S6-03 [EMOVR Independent PID Scale].
■
S6-07: EMOVR Fault Suppression Mode
No.
Name
(Hex.)
S6-07 EMOVR Fault Suppression
Mode
(323E)
0 : Fault Suppression
1 : Test Mode
■
S6-08: EMOVR Drive Enable Input Mode
No.
Name
(Hex.)
S6-08 EMOVR Drive Enable Input
Mode
(323F)
0 : Drive Enable Status Ignored
1 : EMOVRun Only When Drive Disabled
Note:
You must program Drive Enable to a Digital Input for this parameter to have an effect.
456
V/f OLV/PM EZOLV OLV/PM
Sets the number of digits for S6-06 [EMOVR PID Setpoint] when S6-02 = 3[Emergency Override
Ref Selection = Independent PID Mode].
V/f OLV/PM OLV/PM EZOLV
Sets the PID Setpoint when S6-02 = 3[Emergency Override Ref Selection = Independent PID Mode].
V/f OLV/PM OLV/PM EZOLV
Sets the drive to let Emergency Override disable faults during operation.
V/f OLV/PM EZOLV OLV/PM
Sets whether the Drive Enable Input (if programmed) must be inactive (drive is disabled) for
Emergency Override to function.
Description
Description
Description
Description
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
Default
(Range)
2
(0 - 3)
Default
(Range)
0.00
(0 - 600.00)
Default
(Range)
0
(0, 1)
Default
(Range)
0
(0, 1)