Keypad Operation; Home Screen Display Selection - YASKAWA HV600 Manual

3.6

Keypad Operation

Note:
Make sure that you use a keypad with FLASH number 1004 or later. Keypads with FLASH numbers 1003 and earlier will not show
characters correctly.
◆

Home Screen Display Selection

This section gives information about the functions that you can control from the HOME screen and the content shown
on the HOME screen.
■
View Monitors Shown in Home Screen
This figure shows monitor data in the data display area of the HOME screen.
• To change what the screen shows, change the setting for o1-40 [Home display selection].
• When o1-40 [Home display selection] is set to "Custom Monitor", and there is more than one screen, use
to switch between screens.
■
Show the Standard Monitor
Push to show the standard monitor (Ux-xx). Push
Note:
When a fault, minor fault, or an error occurs, push
xx).
■
Change the Frequency Reference Value
1. Push to access the screen to change the frequency.
2. Push or to select the digit, then push
3. Push to keep the changes.
Note:
The HOME screen must show U1-01 [Frequency Reference] or you must set b1-01 = 0 [Frequency Reference Selection 1 = Keypad] to use
this function.
■
Show the Main Menu
Push to show the main menu. Push
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
(HOME) to go back to the HOME screen.
to show the content of the fault. Push
or to change the value.
(HOME) to go back to the HOME screen.

3.6 Keypad Operation

again to show the standard monitor (Ux-
or
3
523