YASKAWA HV600 Manual page 241

Note:
• When you set Jump Frequencies 1 to 3, make sure that the parameters do not overlap.
• When the drive is in the range of the Jump frequency, the frequency reference changes automatically. When Jump is executed, the output
frequency changes smoothly as specified by the values set in C1-01 [Acceleration Time 1] and C1-02 [Deceleration Time 1].
■
d3-01: Jump Frequency 1
No.
Name
(Hex.)
d3-01 Jump Frequency 1
(0294)
Note:
Set this parameter to 0.0 Hz to disable the Jump frequency.
■
d3-02: Jump Frequency 2
No.
Name
(Hex.)
d3-02 Jump Frequency 2
(0295)
Note:
Set this parameter to 0.0 Hz to disable the Jump frequency.
■
d3-03: Jump Frequency 3
No.
Name
(Hex.)
d3-03 Jump Frequency 3
(0296)
Note:
Set this parameter to 0.0 Hz to disable the Jump frequency.
■
d3-04: Jump Frequency Width
No.
Name
(Hex.)
d3-04 Jump Frequency Width
(0297)
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
Figure 2.40 Jump Frequency
V/f OLV/PM OLV/PM EZOLV
Sets the median value of the frequency band that the drive will avoid.
V/f OLV/PM EZOLV OLV/PM
Sets the median value of the frequency band that the drive will avoid.
V/f OLV/PM EZOLV OLV/PM
Sets the median value of the frequency band that the drive will avoid.
V/f OLV/PM EZOLV OLV/PM
Sets the width of the frequency band that the drive will avoid.
Description
Description
Description
Description
2.5 d: References
Default
(Range)
0.0 Hz
(0.0 - 400.0 Hz)
Default
(Range)
0.0 Hz
(0.0 - 400.0 Hz)
Default
(Range)
0.0 Hz
(0.0 - 400.0 Hz)
Default
(Range)
2
1.0 Hz
(Determined by A1-02)
241