Table of Contents
Advertisement
3.2 Overview of Keypad Components and Functions
Note:
1. Refer to
Set up the Drive with General-Purpose Setup Mode on page 462
Applications (Application Presets) on page 471
2. Push
and
the application. The default setting is 0 [General-purpose].
3. To go back to the initial screen, push
Change b1-01 [Frequency Reference Selection 1] from 1 [Analog Input] to 0 [Keypad].
◆
Change Parameter Settings
Show the frequency reference screen in advance.
Note:
Push and hold
to go back to the frequency reference screen from any screen.
Use these steps to change C1-01 [Acceleration Time 1] from 1.0 s (default) to 2.0 s.
◆
Verify and Set the Changed Parameters (Verify Menu)
Show the frequency reference screen.
Note:
Push and hold
to return to frequency reference screen from any screen.
Use Verify mode to view all parameters that are not at default settings. This is very useful when you replace a drive.
When there are no changes to parameter settings, the display shows
changed parameters.
Figure 3.9
464
for more information about Setup mode parameters.
to continue to the application selection screen. When you change the setting, it will optimize the parameter for
. To change another parameter in Setup Mode, push
Figure 3.7 Key operation examples in Setup Mode
Figure 3.8 Key Operation Examples for Parameter Settings
shows the procedure.
and
Automatic Parameter Settings Optimized for Specific
or
. This lets you quickly access and re-edit
YASKAWA TOEPYAIGA5002A GA500 DRIVE PROGRAMMING
.
Advertisement
Table of Contents
