YASKAWA HV600 Manual page 342

2.8 H: Terminal Functions
■
H5-08: Communication Protocol Selection
No.
Name
(Hex.)
H5-08 Communication Protocol
Selection
(062D)
0 : Modbus/MEMOBUS
1 : Metasys/N2
2 : Apogee/P1
3 : BACnet
■
H5-09: CE Detection Time
No.
Name
(Hex.)
H5-09 CE Detection Time
(0435)
■
H5-10: Modbus Register 0025H Unit Sel
No.
Name
(Hex.)
H5-10 Modbus Register 0025H
Unit Sel
(0436)
0 : 0.1 V units
1 : 1 V units
■
H5-11: Comm ENTER Command Mode
No.
Name
(Hex.)
H5-11 Comm ENTER Command
Mode
(043C)
0 : ENTER Command Required
You must use the Enter command to enable changes to parameters. Make all parameter changes then input the Enter
command.
1 : ENTER Command Not Required
It is not necessary to input the Enter command to change parameters.
■
H5-12: Run Command Method Selection
No.
Name
(Hex.)
H5-12 Run Command Method
Selection
(043D)
342
Figure 2.81 Drive Transmit Wait Time
V/f OLV/PM OLV/PM EZOLV
Selects the communication protocol.
V/f OLV/PM EZOLV OLV/PM
Sets the detection time for CE [Modbus Communication Error] issues when communication stops.
V/f OLV/PM OLV/PM EZOLV
Sets the unit of measure used for the MEMOBUS/Modbus communications monitor register 0025H
(output voltage reference monitor).
V/f OLV/PM OLV/PM EZOLV
Sets the function to make the Enter command necessary to change parameters through MEMOBUS/
Modbus communications.
V/f OLV/PM EZOLV OLV/PM
Sets the input method for the Run command when b1-02 = 2 [Run Command Selection 1 = Serial
Communications].
Description
Description
Description
Description
Description
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
Default
(Range)
0
(0 - 3)
Default
(Range)
2.0 s
(0.0 - 10.0 s)
Default
(Range)
0
(0, 1)
Default
(Range)
0
(0, 1)
Default
(Range)
0
(0, 1)