YASKAWA HV600 Manual page 484

2.14 Y: Application Features
Keypad Display
Note:
Parameter o1-82 [Message Screen Display] sets how the drive will show the messages on the keypad. Refer to
Display on page 404 for more information.
■
MEMOBUS Multiplexing System-wide Parameter Entry
This function lets you send parameter changes through the MEMOBUS Multiplex network.
You cannot send the parameters in
No.
A1-03
H5-01
o2-04
o2-09
o3-01
o4-01
o4-03
o4-05
o4-07
Parameter Y9-98 [Network Parameter Push] enables and disables the network parameter push function.
• When Y9-98 = 0 [Disabled], you can only write changes to the drive on which you changed the parameter.
• When Y9-98 = 1 [Enabled/Prompt], changes to system-wide parameters show the prompt shown in
asks to write the change to the selected drive or to all the drives on the network.
The system will only write changes to non-system-wide parameters to the drive on which you changed the parameter.
Refer to Table 2.81 for a list of non-system-wide parameters that you cannot send to other drives on the MEMOBUS
Multiplex network.
484
Table 2.81 to other drives on the MEMOBUS Multiplex network.
Table 2.81 Non-System-Wide Parameters
Name
Initialize Parameters
Drive Node Address
Drive Model (KVA) Selection
Region Code
Copy Keypad Function Selection
Elapsed Operating Time Setting
Fan Operation Time Setting
Capacitor Maintenance Setting
Softcharge Relay Maintenance Set
Network State
• The drive is in HAND Mode
• The drive is ignoring HV600 MEMOBUS commands.
There is an AUTO command, but PI Aux Control or Low City Pressure will not let the
drive operate.
No.
o4-09
o4-11
o4-12
o4-13
q1-xx - q8-xx
Y1-01
Y9-20
Y9-21
Y9-27
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
Full Screen Information
Name
IGBT Maintenance Setting
Fault Trace/History Init (U2/U3)
kWh Monitor Initialization
RUN Command Counter @ Initialize
DriveWorksEZ Parameters
Multiplex Mode
Allow Network Run
Run Priority
Network Recovery
Table 2.82 that