H4: Analog Outputs - YASKAWA HV600 Manual

2.8 H: Terminal Functions
■
30: DWEZ Analog Input 1
Setting Value Function
30 DWEZ Analog Input 1
■
31: DWEZ Analog Input 2
Setting Value Function
31 DWEZ Analog Input 2
◆

H4: Analog Outputs

H4 parameters set the drive analog monitors. These parameters select monitor parameters, adjust gain and bias, and
select output signal levels.
■
Calibrate Meters Connected to MFAO Terminals FM and AM
To calibrate the meters connected to terminals FM and AM, use these parameters:
• H4-02 [Terminal FM Analog Output Gain]
• H4-03 [Terminal FM Analog Output Bias]
• H4-05 [Terminal AM Analog Output Gain]
• H4-06 [Terminal AM Analog Output Bias]
Set these parameters where the output voltage of 10 V and output current of 20 mA are 100% of the signal level. Use
jumper switch S5 and H4-07 [Terminal FM Signal Level Select] or H4-08 [Terminal AM Signal Level Select] to select
the voltage output and current output.
No.
H4-02 Terminal FM Analog Output Gain
H4-03 Terminal FM Analog Output Bias
H4-05 Terminal AM Analog Output Gain
H4-06 Terminal AM Analog Output Bias
H4-07 Terminal FM Signal Level Select
H4-08 Terminal AM Signal Level Select
Figure 2.78 and Figure 2.79
For example, when the parameter value set to analog output is 0, and a 3 V signal is output to terminal FM, H4-03
[Terminal FM Analog Output Bias] is set to 30%.
336
V/f OLV/PM EZOLV OLV/PM
Use with DriveWorksEZ. Refer to the DriveWorksEZ online manual for more information.
V/f OLV/PM EZOLV OLV/PM
Use with DriveWorksEZ. Refer to the DriveWorksEZ online manual for more information.
Name
show the gain and bias when H4-07 = 0 [0 to 10 Vdc] and H4-08 = 0 [0 to 10 Vdc].
Figure 2.78 Analog Output Gain/Bias Configuration Example 1
Description
Description
Range
-999.9 - +999.9%
-999.9 - +999.9%
-999.9 - +999.9%
-999.9 - +999.9%
0: 0 to 10 Vdc
2: 4 to 20 mA
0: 0 to 10 Vdc
2: 4 to 20 mA
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
Default
100.0%
0.0%
50.0%
0.0%
0
0