H3: Analog Inputs - YASKAWA HV600 Manual

2.8 H: Terminal Functions
■
100 to 1C4: Inverse Outputs of 0 to C4
Setting Value Function
100 to 1C4 Inverse Outputs of 0 to C4
For example, set H2-xx = 10E for the inverse output of E [Fault].
◆

H3: Analog Inputs

WARNING! Sudden Movement Hazard. Do test runs and examine the drive to make sure that the command references are correct.
If you set the command reference incorrectly, it can cause damage to the drive or serious injury or death.
Drives have two analog input terminals, terminals A1 and A2. H3 parameters select the functions set to these analog
input terminals and adjust signal levels.
Table 2.55 shows the functions that you can set to analog input terminals. Use H3-02 and H3-10 [MFAI Function
Selection] to set functions.
Setting
Value
0 Frequency Reference
1 Frequency Gain
2 Auxiliary Frequency Reference 1
3 Auxiliary Frequency Reference 2
4 Output Voltage Bias
5 Accel/Decel Time Gain
6 DC Injection Braking Current
7 Torque Detection Level
8 Stall Prevent Level During Run
9 Output Frequency Lower Limit
B PID Feedback
C PID Setpoint
D Frequency Bias
E Motor Temperature (PTC Input)
F Not Used
10 Forward Torque Limit
Note:
All analog input scaling uses gain and bias for adjustment. Set the gain and bias values correctly.
324
V/f OLV/PM EZOLV OLV/PM
Causes inverse output of the function for the selected MFDO. Uses the last two digits of 1xx to select which function to inversely
output.
Table 2.55 MFAI Setting Values
Function
Description
Setting
Ref.
Value
329 11 Reverse Torque Limit
330 12 Regenerative Torque Limit
330 15 General Torque Limit
330 16 Differential PID Feedback
330 1F Not Used
330 24 PID Feedback Backup
331 25 PI2 Control Setpoint
331 26 PI2 Control Feedback
331 27 PI Auxiliary Control Feedback
332 2B Emergency Override PID Feedback
332 2C Emergency Override PID Setpoint
332 2D Differential Level Source
332 2E Hand Frequency Ref or Setpoint
332 30 DWEZ Analog Input 1
333 31 DWEZ Analog Input 2
333
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
Function Ref.
334
334
334
334
334
335
335
335
335
335
335
335
335
336
336