YASKAWA HV600 Manual page 579

3.
Pull part A of the front cover forward to remove the cover from the drive.
A - Pull forward to remove the front cover.
4.
Remove the front cover from the drive.
■
Reattach the Front Cover
Wire the drive and other peripheral devices then reattach the front cover.
1.
Move the front cover to connect the hooks at the top of the front cover to the drive.
A - Hooks
2.
Move the front cover while pushing on the hooks on the left and right sides of the front cover until it clicks into
position.
Note:
Make sure that you did not pinch wires or signal lines between the front cover and the drive before you reattach the cover.
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
Figure 4.9 Pull Forward to Remove the Front Cover
Figure 4.10 Remove the Front Cover
Figure 4.11 Reattach the Front Cover
4.2 Removing/Reattaching Covers
4
579