YASKAWA HV600 Manual page 322

2.8 H: Terminal Functions
■
A9: RELAY Operator Control
Setting Value Function
A9 RELAY Operator Control
■
AA: Utility Delay
Setting Value Function
AA Utility Delay
■
AB: Thrust Mode
Setting Value Function
AB Thrust Mode
■
AC: Setpoint Not Maintained
Setting Value Function
AC Setpoint Not Maintained
■
B2: BAS Interlock
Setting Value Function
B2 BAS Interlock
■
B8: Pump Fault
Setting Value Function
B8 Pump Fault
■
B9: Transducer Loss
Setting Value Function
B9 Transducer Loss
■
BA: PI Auxiliary Control Active
Setting Value Function
BA PI Auxiliary Control Active
■
BB: Differential Feedback Exceeded
Setting Value Function
BB Differential Feedback
Exceeded
322
V/f OLV/PM OLV/PM EZOLV
The terminal changes to OFF or ON when you push the RELAY (
it OFF. When the terminal is OFF, push
V/f OLV/PM EZOLV OLV/PM
The terminal activates when the drive is stopped and is waiting for the timer set in Y4-17 [Utility Start Delay] to expire.
V/f OLV/PM OLV/PM EZOLV
The terminal activates when the output frequency is between 0.0 Hz and the value set in Y4-12 [Thrust Frequency] and the Thrust
Bearing function is active.
V/f OLV/PM EZOLV OLV/PM
The terminal activates when the drive detects NMS [Setpoint Not Met] condition.
V/f OLV/PM EZOLV OLV/PM
The terminal activates when the Run command is active or the drive is outputting the voltage. The drive will use this as an actuation
signal for an external damper.
V/f OLV/PM EZOLV OLV/PM
The terminal activates when one of these faults is active: LFB [Low Feedback Sensed], HFB [High Feedback Sensed], NMS
[Setpoint Not Met], or EFx [External Fault (Terminal Sx)].
V/f OLV/PM OLV/PM EZOLV
The terminal activates when the current into the analog input associated with PID feedback is more than 21 mA or less than 3 mA,
or an FDBKL [WIRE Break] Fault or an FDBKL [Feedback Loss Wire Break] Alarm is active.
V/f OLV/PM EZOLV OLV/PM
The terminal activates when the PI Auxiliary Controller has an effect on the output speed.
V/f OLV/PM EZOLV OLV/PM
The terminal activates when the difference between the PID Feedback and the value from the terminal set for H3-xx = 2D
[Differential Feedback] is more than Y4-18 [Differential Level] for the time set in Y4-19 [Differential Lvl Detection Time].
Description
) button. When the terminal is ON, push
to turn in ON.
Description
Description
Description
Description
Description
Description
Description
Description
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
to turn