Show Monitors As An Analog Gauge - YASKAWA HV600 Manual

1.
Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push (Menu).
3.
Push or
4.
Push or
5.
Push .
6.
Push or
Enter the three digits in "x-xx" part of monitor Ux-xx to identify which monitor to output. For example, to show
monitor U1-01 [Frequency Reference], set it to "101" as shown in this figure.
The configuration procedure is complete.
◆

Show Monitors as an Analog Gauge

The following explains how to display the contents selected for a monitor as an analog gauge.
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
, push (Back) to show [Home] on
to select [Monitors], then push
to select [Analog Gauge], then push
to select the monitor number to register, then push
.
.
(Setup).
.
3.6 Keypad Operation
529
3