YASKAWA HV600 Manual page 316

2.8 H: Terminal Functions
■
1A: During Reverse
Setting Value Function
1A During Reverse
ON : The motor is operating in the reverse direction.
OFF : The motor is operating in the forward direction or the motor stopped.
■
1B: During Baseblock (N.C.)
Setting Value Function
1B During Baseblock (N.C.)
ON : The drive is not in baseblock.
OFF : During baseblock
■
1C: Motor 2 Selected
Setting Value Function
1C Motor 2 Selection
ON : Motor 2 Selection
OFF : Motor 1 Selection
■
1E: Executing Auto-Restart
Setting Value Function
1E Executing Auto-Restart
The terminal deactivates when the Auto Restart function automatically resets a fault. The terminal deactivates when
the Auto Restart function detects the fault again because there were too many restart attempts as specified by L5-01
[Number of Auto Restart Attempts].
Note:
Refer to L5: Fault Restart on page 369
■
1F: Motor Overload Alarm (oL1)
Setting Value Function
1F Motor Overload Alarm
(oL1)
Note:
Refer to "L1-01: Motor Overload (oL1) Protection" for more information.
316
V/f OLV/PM EZOLV OLV/PM
The terminal activates when the motor operates in the reverse direction.
Figure 2.69 Reverse Operation Output Time Chart
V/f OLV/PM OLV/PM EZOLV
The terminal deactivates during baseblock. When the drive is in baseblock, the drive output transistor stops switching and does not
make DC bus voltage.
V/f OLV/PM OLV/PM EZOLV
The terminal activates when you select motor 2.
V/f OLV/PM OLV/PM EZOLV
The terminal activates when the Auto Restart function is trying to restart after a fault.
for more information.
V/f OLV/PM EZOLV OLV/PM
The terminal activates when the electronic thermal protection value of the motor overload protective function is a minimum of 90%
of the detection level.
Description
Description
Description
Description
Description
YASKAWA TOEPYAIHV6002A HV600 Drive Programming