YASKAWA HV600 Manual page 407

Note:
The drive will not reset the HOME screen display if an alarm or message occurs.
When the keypad must show more than one status (Alarms/Faults, Information Text, Messages) on the Status
Monitor, the keypad will cycle a different display each 2 s.
If there is a new alarm or fault, it will stop the display cycle and the keypad will show the alarm or fault screen for 1 s.
The keypad will then start the 2-second display cycles again from the Information Text display screen.
If the Information Text only has an effect on the second line, the keypad will show a Message or an Alarm on the
third line. The Message display has priority because it is possible to have more than one active Message at the same
time.
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
Figure 2.110 Display for Fault
Table 2.65 Displays for More than One Status
Keypad Display
2.11 o: Keypad-Related Settings
Description
When the keypad must show an alarm and message at the
same time, it will toggle the second and third lines each 2 s.
When the keypad must show an Information Text only on
the second line and an alarm at the same time, it will toggle
the second line each 2 s.
When the keypad must show an Information Text only on
the second line and a message at the same time, it will
toggle the second line each 2 s.
2
407