YASKAWA HV600 Manual page 490

2.14 Y: Application Features
■
Y9-17: Setpoint Modifier
No.
Name
(Hex.)
Y9-17 Setpoint Modifier
(3E04)
RUN
■
Y9-18: High Feedback De-stage Level
No.
Name
(Hex.)
Y9-18 High Feedback De-stage
Level
(3E05)
RUN
Note:
• The quick de-stage ignores parameters Y9-12 [De-staging Mode] to Y9-15 [De-staging Delay Time] and only uses an internal 2 s delay.
• Set this parameter to 0.0 to disable the function.
■
Y9-19: Alternation Time Unit
No.
Name
(Hex.)
Y9-19 Alternation Time Unit
(3E06)
RUN
Note:
You can use this parameter only when Y1-03 = 3 [Multiplex Mode = Memobus Network].
0 : Hours (H)
1 : Minutes (min)
■
Y9-20: Allow Network Run
No.
Name
(Hex.)
Y9-20 Allow Network Run
(3E07)
0 : Always
Drive will respond to all network Run commands (first drive, staging, or alternation).
1 : First/Alternation
Drive can only be the first drive or for alternation.
2 : First Only
The drive can only be a first drive.
3 : Alternation Only
The drive is only available for alternation.
■
Y9-21: Run Priority
No.
Name
(Hex.)
Y9-21 Run Priority
(3E08)
RUN
490
V/f OLV/PM EZOLV OLV/PM
Sets the value by which the system setpoint is incremented as specified by the number of drives that
are running.
V/f OLV/PM OLV/PM EZOLV
Sets the feedback level to trigger a quick de-stage as a percentage of Y1-11 [High Feedback Level].
V/f OLV/PM EZOLV OLV/PM
Sets the units for Y9-03 [Alternation Time]. You can set this parameter to 1 [Minutes (min)] during
commission to test the alternation function.
V/f OLV/PM EZOLV OLV/PM
Sets when the drive will respond to a network Run command.
V/f OLV/PM OLV/PM EZOLV
Sets the Lead Drive selection priority to override the Y9-01 [Lead Drive Selection] selection.
Description
Description
Description
Description
Description
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
Default
(Range)
0.00
(-99.99 - +99.99)
Default
(Range)
97.0%
(0.0 - 100.0%)
Default
(Range)
0
(0, 1)
Default
(Range)
0
(0 - 3)
Default
(Range)
8
(1 - 16)