Configuring The Data Log Content - YASKAWA HV600 Manual

5.
Push or
6.
Push or
• [Yes]: Data logging starts.
• [No]: Data logging will not start.
If the drive was logging data when you entered the command, the keypad looks like this:
◆

Configuring the Data Log Content

■
Set Monitor to Log
The procedure in this section shows how to set the monitor for which to log data.
1.
Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If the screen does not show [Home] for
2.
Push (Menu).
3.
Push or
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
to select [Data Logger], then push
to select [Yes] or [No], then push
, push
to select [Diagnostic Tools], then push
.
.
(Back), and then push
.
3.6 Keypad Operation
to show [Home].
3
553