YASKAWA HV600 Manual page 412

2.11 o: Keypad-Related Settings
■
o1-37: LCD Backlight ON/OFF Selection
No.
Name
(Hex.)
o1-37 LCD Backlight ON/OFF
Selection
(11BA)
RUN
Note:
Use o1-36 [LCD Backlight Brightness] to adjust the intensity of the LCD backlight.
0 : OFF
The automatic backlight shut off function is enabled. The backlight will automatically turn off after the time set in o1-
38 [LCD Backlight Off-Delay] is expired.
Note:
When o1-37 = 0 and the backlight is OFF, the keys other than
When the backlight is OFF, push a key on the keypad to temporarily turn the backlight ON. To use the key function to operate the drive, push
the same key again. For example, push
1 : ON
The automatic backlight shut off function is disabled. The backlight will always be ON.
■
o1-38: LCD Backlight Off-Delay
No.
Name
(Hex.)
o1-38 LCD Backlight Off-Delay
(11BB)
RUN
When o1-37 = 0 [LCD Backlight ON/OFF Selection= OFF], the backlight will automatically turn off after the time
set in o1-38 expires.
When the backlight is off, push a key on the keypad to temporarily turn the backlight on. After the backlight turns on,
it will turn off automatically after the time set in o1-38 is expired.
■
o1-39: Show Initial Setup Screen
No.
Name
(Hex.)
o1-39 Show Initial Setup Screen
(11BC)
RUN
The initial setup screen shows a menu where you can select the display language, set the date, time, and other basic
settings. When you set this parameter to 0, the drive will not show this screen each time you energize the drive.
0 : No
The drive will not show the initial setup display screen each time you energize the drive. The drive will show the
Home screen.
1 : Yes
When you input the Run command before you energize the drive or when the you turn on the Run command while the
drive shows the initial setup screen, the drive will replace the initial setup screen with the Home screen.
■
o1-40: Home Screen Display Selection
No.
Name
(Hex.)
o1-40 Home Screen Display
Selection
(11BD)
RUN
412
V/f OLV/PM OLV/PM EZOLV
Sets the automatic shut off function for the LCD backlight.
to turn the backlight ON, then push
V/f OLV/PM EZOLV OLV/PM
Sets the time until the LCD backlight automatically turns off.
V/f OLV/PM EZOLV OLV/PM
Sets the function to show the HOA keypad initial setup screen each time you energize the drive. This
parameter is only available on an HOA keypad.
V/f OLV/PM EZOLV OLV/PM
Sets the monitor display mode for the Home screen. This parameter is only available on an HOA
keypad.
Description
are disabled.
again to enter a Run command to the drive.
Description
Description
Description
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
Default
(Range)
0
(0, 1)
Default
(Range)
60 s
(10 - 300 s)
Default
(Range)
1
(0, 1)
Default
(Range)
0
(0 - 3)