YASKAWA HV600 Manual page 531

■
Select Monitor Items to Show as a Trend Plot
The procedure in this section shows how to show the frequency reference monitor as a trend plot.
1.
Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push (Menu).
3.
Push or
4.
Push or
5.
Push or
6.
Push .
7.
Push or
When the U parameters are on the display as "Ux-xx", the three digits in "x-xx" identify which monitor to
output. For example, to show monitor U1-01 [Frequency Reference], set it to "101" as shown in this figure.
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
, push (Back) to show [Home] on
to select [Monitors], then push
to select [Trend Plot], then push
to select [Custom Monitor 1], then push
to select the monitor number to register, then push
.
.
(Setup).
.
.
3.6 Keypad Operation
531
3