YASKAWA HV600 Manual page 292

2.8 H: Terminal Functions
Signal Input Method from
Peripheral Devices
Setting
N.O.
2A x
2B -
2C x
2D -
2E x
2F -
*1 Set the terminal to N.O. (detects external fault when switched ON) or N.C. (detects external fault when switched OFF).
*2 Set the drive to always detect each fault or to detect only during run.
■
30: PID Integrator Reset
Setting Value Function
30 PID Integrator Reset
Note:
Refer to "PID control block diagram" for more information.
■
31: PID Integrator Hold
Setting Value Function
31 PID Integrator Hold
When you turn off the input terminal, PID control restarts the integral.
Note:
Refer to "PID control block diagram" for more information.
■
34: PID Soft Starter Disable
Setting Value Function
34 PID Soft Starter Disable
ON : Disabled
Disables b5-17 [PID Accel/Decel Time].
OFF : Enabled
Enables b5-17 [PID Accel/Decel Time].
Note:
Refer to "PID control block diagram" for more information.
■
35: PID Input (Error) Invert
Setting Value Function
35 PID Input (Error) Invert
Note:
Refer to "PID control block diagram" for more information.
292
External Fault Detection Method
*1 *2
Always Detected during
N.C.
Detected RUN Only
- -
x -
- x
x x
- -
x -
V/f OLV/PM OLV/PM EZOLV
Sets the command to reset and hold the PID control integral to 0 when the terminal is ON.
V/f OLV/PM EZOLV OLV/PM
Sets the command to hold the integral value of the PID control while the terminal is activated.
V/f OLV/PM OLV/PM EZOLV
Sets the PID soft starter function.
V/f OLV/PM OLV/PM EZOLV
Sets the command to turn the terminal ON and OFF to switch the PID input level (polarity).
Ramp to Stop Coast to Stop
(Fault) (Fault)
x -
x -
- -
- -
x -
x -
Description
Description
Description
Description
YASKAWA TOEPYAIHV6002A HV600 Drive Programming
Stopping Method
Continuous
Fast Stop
Operation
(Fault)
(Alarm Only)
- x
- x
- -
- -
- -
- -
-
-
x
x
x
x