Honda Accord 2008 Manual page 2159

07/11/02 09:31:16 61TA0000_220_0129
Multiplex Integrated Control System
Troubleshooting - B-CAN System Diagnosis Test Mode 1 and Test Mode 2
(without the HDS) (cont'd)
Driver's MICU
Brake pedal position switch (ON)
Driver's door switch
Left rear door switch (4-door)
Trunk lid latch switch
Left rear door lock knob switch (UNLOCK)
(4-door)
Wiper switch (HI/LO)
Wiper switch (INT/LO)
Wiper switch (MIST)
Washer switch
Wiper intermittent dwell time controller
Turn signal switch (LEFT)
Turn signal switch (RIGHT)
Hazard warning switch (ON)
Headlight switch (ON)
Headlight switch (OFF)
Lighting switch (ON)
Dimmer switch (ON)
Passing switch (ON)
A/C pressure switch
Transmission range switch (P) (A/T)
Ignition key switch
Hood switch
Back-up light switch
Wiper motor park position (Auto stop)
Rear window defogger switch (HVAC only)
Passenger's MICU
Front passenger's door switch
Right rear door switch (4-door)
Right rear door lock knob switch (UNLOCK)
(4-door)
22-126
Item
Item
Door Multiplex Control Unit
Item
Driver's door lock switch (UNLOCK)
Driver's door lock switch (LOCK)
Driver's door lock knob switch (UNLOCK)
Driver's door lock knob switch (LOCK)
Driver's door lock key cylinder switch
(UNLOCK)
Driver's door lock key cylinder switch (LOCK)
A second key is necessary to check the key
cylinder inputs. Be sure to rotate the key cylinder
switch two times to each position (lock and lock,
unlock and unlock) to ensure the door lock knob
switch is in the appropriate position.
Front Passenger's Power Window Switch
Item
Front passenger's door lock switch (UNLOCK)
Front passenger's door lock switch (LOCK)
Front passenger's door lock knob switch
(UNLOCK)
Does the ceiling light work properly in all switch
positions?
−
YES Go to function and input test for the system
related to the failure.
NO − Repair the open, short, or replace the faulty
switch.