13) Insert the Toner Container all the way in, and close the Toner Exchange Cover.
14) Close the Toner Cover.
NOTE:
•
Toner refill will be executed.
•
Once the host machine goes to standby state, drum initialization, developing assembly
initialization and toner refill are completed.
9
Installation > Installation Procedure > Setting for K Paper (China only)
1) Turn OFF the main power switch of the host machine.
2) Be sure that Control Panel Display and Main Power Lamp are both turned OFF, and then
disconnect the power plug.
Make the following settings for the use of K paper.
1) Enter the service mode (level 2).
2) Change from '0' to '1' in COPIER > OPTION > FNC-SW > KSIZE-SW.
3) Enter the service mode (level 1).
4) Change from '4' to '0' in COPIER > OPTION > FNC-SW > MODEL-SZ.
5) Turn OFF/ON the main power switch.
F-9-52
9
Installation > Installation Procedure > Setting for K Paper (China only)
Turning OFF the Main Power Switch
Setting for K Paper (China only)
9-25
9-25