Checking before Installation
Following shows requirements for the installation site. Therefore, it is desirable to see the installation site inadvance before
bringing in this equipment to the user's site.
Checking the Installation Space
The minimum space shown in the figure is required for installation and maintenance.
Check Items when turning OFF the Main Power
Check that the main power switch is OFF.
1. Turn OFF the main power switch of the host machine.
2. Be sure that control panel display and main power lamp are both turned OFF, and then disconnect the power plug.
Points to Note at Installation
• This installation procedure is written only about the installation of the inner finisher. When installing the inner puncher unit
together with the finisher, refer to the installation procedure supplied with the inner puncher unit instead of referring this
installation procedure.
• Marked portion
When tightening the screws, do not tighten them too tightly. Otherwise, there is a risk of damage and deformation of screw
holes.
Product Name
Safety regulations require the product's name to be registered. In some regions where this product is sold, the following names
may be registered instead.
F281122
100 mm or more
500 mm or more
87
6. Installation