Show Ip Redist - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

IP Commands

show ip redist

Displays the IPv4 route map redistribution configuration.
show ipv6 redist [rip]
Syntax Definitions
rip
Defaults
By default all route map redistribution configurations are shown.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Specify a destination protocol with this command to display only those configurations that redistribute
routes into the specified protocol.
Release History
Release 6.6.1; command was introduced.
Examples
-> show ip redist
Source Destination
Protocol Protocol
------------+------------+---------+--------------------
RIP Static
-> show ip redist rip
Source Destination
Protocol Protocol
------------+------------+---------+--------------------
Static
output definitions
Source Protocol
Destination Protocol
Status
Route Map
OmniSwitch 6250 CLI Reference Guide
Displays route map redistribution configurations that use RIP as the
destination (into) protocol.
Status
Enabled
Status
RIP Enabled
The protocol from which the routes are learned.
The protocol into which the source protocol routes are redistributed.
The administrative status (Enabled or Disabled) of the route map
redistribution configuration.
The name of the route map that is applied with this redistribution
configuration.
November 2009
Route Map
ipv4rm
Route Map
ipv4rm
page 29-87