Show Arp - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show arp

Displays the ARP table. The ARP table contains a listing of IP addresses and their corresponding transla-
tions to physical MAC addresses.
show arp [ip_address | hardware_address]
Syntax Definitions
ip_address
hardware_address
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the basic command (show arp) to view all of the entries in the table. Enter a specific IP address or
MAC address to view a specific entry.
Examples
-> show arp
Total 8 arp entries
Flags (P=Proxy)
IP Addr
-----------------+-------------------+----------+-------+--------+----------+------
10.255.11.59
10.255.11.48
10.255.11.201
10.255.11.14
10.255.11.64
10.255.11.25
10.255.11.26
10.255.11.254
output definitions
IP Address
Hardware Addr
Type
Flags
Port
Interface
Name
page 29-100
IP address of the entry you want to view.
MAC address of the entry you want to view.
Hardware Addr
00:50:04:b2:c9:ee
00:50:04:b2:ca:11
00:10:83:03:e7:e4
00:10:5a:04:19:a7
00:b0:d0:62:fa:f1
00:b0:d0:42:80:24
00:b0:d0:42:82:59
11:50:04:11:11:11
Device IP address.
MAC address of the device that corresponds to the IP address.
Indicates whether the ARP cache entries are dynamic or static.
Indicates the type of entry:
•
P = Proxy
The port on the switch attached to the device identified by the IP
address.
The interface to which the entry belongs (e.g., VLAN, EMP).
User configured name of static arp entry.
Type Flags Port
DYNAMIC
DYNAMIC
DYNAMIC
DYNAMIC
DYNAMIC
DYNAMIC
DYNAMIC
STATIC
OmniSwitch 6250 CLI Reference Guide
IP Commands
Interface Name
3/20 vlan 1
3/20 vlan 1
3/20 vlan 1
3/20 vlan 1
3/20 vlan 1
3/20 vlan 1
3/20 vlan 1
3/20 vlan 1 demoarp
November 2009