Wheel Runout; Wheel Balance - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

5A-18
Weight point
Balance weight
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN

Wheel Runout

Measure wheel runout with an accurate dial indicator. Mea-
surement may be taken with the wheels either on or off the
vehicle, using an accurate mounting surface such as a wheel
balancer. Measurements may be taken with or without the
tire mounted on the wheel.
1. Measure the dial runout and lateral runout on both the
Y220_05A044
2. Measure free radial runout on the tire tread.

Wheel Balance

Balance is the easiest procedure to perform and should be
done first if the vibration occurs at high speeds or if the tires or
the wheels are replaced.
When proceeding the wheel balancing procedure refer to the
following;
1. Do not the wheel weight over two at the inboard and the
2. The total weight ofthe wheel weight should not exceed
Y220_05A045
3. Balancing the assemblies with the factory aluminum
Balance weight
Balance weight
10 g
0.4 oz
Weight point
Y220_05A046
inboard and outboard rim flanges.
Specification
Specification
Notice
If any measurement exceeds the above specifications,
replace the applicable tires or wheels.
outboard flanges.
the 150 g (3.5 ounces)
wheels requires the use of the special nylon-coated, clip-
on wheel weights.
20 g 30 g
0.7 oz 1.10 oz
2.66 mm
2.03 mm
40 g 50 g 60 g
1.40 oz 1.80 oz 2.10 oz
WHEELS & TIRE
REXTON SM - 2004.4