Theft Warning; Description Of Theft Warning Function - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

THEFT WARNING

Theft Warning Selection
1. When the theft warning selection switch is "ON"
- When a warning operating condition occurs, the warning outputs (Hazard relay/Siren) will not be done. However,
if the armed mode is started, the hazard relay output is "ON".
- When turning "OFF" the theft warning selection switch from "ON" while the operating condition is present, the
warning operation output will not be done.
2. When the theft warning selection switch is "OFF"
- When a warning operating condition occurs, the warning outputs (Hazard relay/Siren) will be done.
- When turning "ON" the theft warning selection switch from "OFF" during the warning output, the warning
operation output can be done by remained time.
3. Determination for ON/OFF position of theft warning selection switch
- Can be determined only when the theft warning operating is in normal mode (before receiving Tx LOCK signal).
- Disregards the changes of theft warning selection switch in the armed mode or warning operation.
4. Definition of terms
Door
OPEN: Door switch (hood, driver's door, passenger's door, rear doors and tailgate) = OPEN
CLOSE: Door switch (hood, driver's door, passenger's door, rear doors and tailgate) = CLOSE
Door Lock Switch
LOCK: Door lock switch (driver's door, passenger's door, rear doors and tailgate) = LOCK
UNLOCK: Door lock switch (driver's door, passenger's door, rear doors and tailgate) = UNLOCK

Description of Theft Warning Function

1. Armed mode activation requirements
- The "LOCK" output is "ON" when receiving the T x LOCK signal while the ignition key is removed and all doors
are closed. The armed mode is activated when the door lock switch is locked (siren output: once, hazard relay
output: twice)
- The siren and hazard relay outputs are "ON" when receiving T x LOCK signal again in armed mode (maintaining
the armed mode).
- When receiving Tx LOCK signal while any of doors are not closed, only the "LOCK" output can be done and
then activates the armed ready mode (without siren and hazard relay output). At this moment, if the ignition key
is in the ignition switch, the door unlock switch is turned "ON" or the door lock switch is unlocked (after 0.6
seconds), cancels the armed mode and activates the normal mode. However, in these cases, if closing the
door and locking the door lock switch, the siren outputs once and the hazard relay outputs twice and then
activates armed mode.
- When the door is opened, the door unlock switch is "ON" or the ignition key is not inserted into ignition switch
for 30 seconds after receiving T x UNLOCK signal, outputs "LOCK" and then activates armed mode (RELOCK
operation).
- The armed mode will not be activated except above conditions.
ex) The armed mode is not activated when locked by door unlock switch.
ELECTRIC SYSTEM
REXTON SM - 2004.4
9B-29
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN