SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 742

20. Assemble the pump to the pump cover.
21. Tighten all bolts and the crescent screw finger tight,
ensuring that the pump is flush against the pump cover.
Tighten the bolts and the screw to specification in the
order. (A-F)
Installation Notice
Bolt (A-E): 24 ~ 27 Nm (18 ~ 20 lb-ft)
Tightening
torque
Screw (F): 13 ~ 16 Nm (10 ~ 12 lb-ft)
22. Install the pump to transmission case gasket onto the
case.
23. Fit the "O" ring to the pump cover outer diameter.
24. Install the pump and cover assembly over the input shaft
being careful not to damage the sealing rings. Apply
additional Loctite 202 or equivalent as required to the
pump cover to case bolts. Install and tighten bolts to
specification.
Installation Notice
Tightening torque
25. Check that the transmission end float is 0.50 ~ 0.65
mm. If the unshimmed end float clearance is greater than
specification, shims are to be placed between the No. 4
bearing and the input shaft bearing surface. If the end
float clearance is less than 0.5 mm then the transmission
has been assembled incorrectly or the parts are out of
specification.
26. Perform the following steps to check the end float :
a. Attach a dial indicator to the front of the trans-mission
case with the stylus resting on the end of the input
shaft.
b. Apply a force of approximately 250 N or 25 kg to the
input shaft.
c. Zero the dial indicator.
d. Place a small lever behind the forward clutch cylinder
and lever the cylinder forward.
e. The measurement recorded on the dial indicator is
the transmission end float or clearance between the
No.4 bearing and the converter support tube.
27. On completion of this procedure, adjust the front and
rear bands to specifications. Refer to "Front and Rear
Band Adjustment" in this section.
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4
24 ~ 34 Nm (18 ~ 25 lb-ft)
3A2-193
Y220_3A21L0
Y220_3A21M0
Y220_3A21N0
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN