SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 843

8. Set up the dial gauge on the transmission housing surface
and put the gauge needle to "0" point.
9. Put the probe end of the gauge on the taper roller bearing
outer race in counter gear and measure the end play.
* If the measured value is out of the specified range,
adjust it by using spacers.
End play
10. Put the probe end of the gauge on the main taper roller
bearing outer race and measure the end play.
* If the measured value is out of the specified range,
adjust it by using spacers
End play
11. Apply the sealant to the front fork cover and tighten the
bolts. Measure the starting torque after installation.
Starting torque
Sealant
Tightening torque
TSM54/52 MANUAL TRANSMISSION
REXTON SM - 2004.4
0.05 ~ 0.1 mm
0.05 ~ 0.1 mm
20 ~ 25 Nm
LOCTITE 5900
17 ~ 26 Nm
3B-77
Y220_03B190
Y220_03B192
Y220_03B193
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN