SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 733

3A2-184
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
26. Check the clutch pack clearance using only the weight
from 0555-336260 clutch pack clearance kit.
Notice
With the clutch pack supporting a 2 kgweight, the
dimension from the C3 clutch hub locating step to
the friction plate is to be between 0.80 ~ 1.05 mm.
27. Use selective plates to achieve the correct specifica-tion.
If new friction plates are being fitted, remove the clutch
pack and soak the friction plates in ATF for a minimum
of 5 minutes prior to reassembly.
Y220_3A20M0
Notice
The clutch pack clearance must be taken before the
elements are soaked in ATF.
28. Lubricate and fit the 3-4 OWC and end caps to the C2
hub.
29. Align the tangs and fit the nylon thrust washer onto the
C4 hub.
30. Align and fit the C4 hub to the C2 clutch and the OWC
assembly.
31. Check the rotation of the C2 hub. While holding the C4
hub, the C2 hub should rotate in the clockwise direction
and lockup in the anti-clockwise direction when viewed
from the C2 hub.
Y220_3A20N0
32. Apply petroleum jelly to the No. 5 needle bearing and fit
it to the C4 hub.
33. Remove the C2 clutch plates from the clutch cylinder.
34. Fit the thrust plate over the cylinder inner hub.
35. Engage the C2/C4 clutch hub assembly in the C4 clutch
plates.
36. Install the C2 clutch plates.
37. Install the C3 hub and secure it with the circlip, ensuring
that the circlip is firmly seated in its groove.
Y220_3A20O0
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4