Fuel Gauge; Checking The Fuel Sender Resistance; Fuel Sensor - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

Fuel Gauge

1. Disconnect the fuel sender connector.
2. Ground the harness side connector (B11, B14) through
12 V, 3.4 W lamp.
3. Turn the ignition switch to "ON" position.
4. Check it the test lamp comes on and the fuel gauge
pointer moves to "F" slowly.

Checking the fuel sender resistance

1. Place the float at "F" and "E" and measure the resistance between B11 and B14.
2. Check if the resistance is slowly changed when the float moves to "F" from "E".
2 FUEL Indication
LEVEL
GAUGE Indicating Angle
GAUGE Tolerance
Diesel F/SENSOR Resistance
Gasoline Fuel Level
Communication Data(HEX)

Fuel sensor

1. Connect the test lamp (12 V, 3.4 W) of fuel gauge terminal and soak the thermister into water.
2. Check if the test lamp goes off when the thermister is under water, and vice versa.
Note
• Replace the fuel sender assembly if needed.
• Thoroughly dry the fuel sender before installation.
INSTRUMENT PANEL AND MULTI-METER
REXTON SM - 2004.4
Measuring Condition (VIN= 13 ± 0.1 V, Condition: 25°C)
FULL (3/4)
80° 60°
+4.0 -
-1.0
40 Ω 67 Ω
78.3 60.6
9C 79
1/2 1/4
40° 20°
±5 -
99.5 Ω 152 Ω
43.0 25.0
56 32
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
9C-13
Y220_09C221
EMPTY
0°
±2.5
285 Ω
7.0
E