SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 924

3E-28
Code
P1835 Too low speed sensor reference voltage
P1836 Too high speed sensor reference voltage
P1841 Open to ground in shift motor circuit
P1842 Short to ground in shift motor output circuit
Shift system timeout
P1843
Too low position encoder voltage
P1844
(Stuck in Low)
Defective position encoder
P1850
Short to ground for position encoder 1
P1851
Short to ground for position encoder 2
P1852
Short to ground for position encoder 3
P1853
Short to ground for position encoder 4
P1854
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
Description
- Reference voltage: below 4 V
- Check the relevant harnesses.
- Check the relevant connectors for contact.
- Replace sensors if necessary.
- Reference voltage: over 8V
- Check the relevant harnesses.
- Check the relevant connectors for contact.
- Replace sensors if necessary.
- When TCCU detects the motor failure for 1 second (Action:
IG switch ON)
- Check the relevant harnesses for contact.
- Replace shift motor if necessary.
- When TCCU detects the motor failure for 1 second
(Action: IG switch ON)
- Check the relevant harnesses for contact.
- Replace shift motor if necessary.
- 2H-4H: after 1.5 seconds
- 4H-4L: after 3 seconds
- Check the relevant harnesses for contact.
- Replace shift motor if necessary.
- When no signals from the position encoder
- Check the relevant harnesses for contact.
- Replace shift motor if necessary.
- When the position encoder is defective
- Check the relevant harnesses.
- Check the relevant connectors for contact.
- Check the shift motor.
- Short to ground for position encoder 1 in shift motor
- Check the relevant harnesses for short.
• TCCU pin No. B15
- Check the relevant connectors for contact.
- Check the shift motor.
- Short to ground for position encoder 2 in shift motor
- Check the relevant harnesses for short.
• TCCU pin No. B5
- Check the relevant connectors for contact.
- Check the shift motor.
- Short to ground for position encoder 3 in shift motor
- Check the relevant harnesses for short.
• TCCU pin No. B16
- Check the relevant connectors for contact.
- Check the shift motor.
- Short to ground for position encoder 4 in shift motor
- Check the relevant harnesses for short.
• TCCU pin No. B18
- Check the relevant connectors for contact.
- Check the shift motor.
Action
REXTON SM - 2004.4
TOD