SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 609

Trouble
Defectives
Code
P2107 Defective modulator pressure sole-
noid valve
P2108 Defective shift pressure solenoid
valve
P2200 Faulty rpm sensor N2 signal
P2203 Faulty rpm sensor N3 signal
P220A Abnormal rpm sensor output signal
(N2, N3)
P2220 Oil temperature sensor - short
P2221 Abnormal oil temperature sensor
signal
P2222
Abnormal oil temperature sensor
signal
P2300
Faulty CAN communication
DC 5-SPEED AUTOMATIC TRANSMISSION
REXTON SM - 2004.4
- Measure the resistance of modulator pressure solenoid valve (turn the
IGN OFF, then disconnect TCU connector).
• TCU connector terminals: B5, B3
• Specified value: 5.0 ± 0.2 Ω
- Triggered emergency mode when the defective is detected.
• Fixed at 2nd gear in "D" range.
- Check the related harness for open, short and contact.
- Measure the resistance of shift pressure solenoid valve (turn the IGN
OFF, then disconnect TCU connector).
• TCU connector terminals: B4, B3
• Specified value: 5.0 ± 0.2 Ω
- Triggered emergency mode when the defective is detected.
• Electrical error: Fixed at 2nd gear in "D" range.
- Check the related harness for open, short and contact.
- When the rpm sensor N2 detects 0 rpm of front sun gear speed.
- Check the related harness for open, short and contact.
• TCU connector terminal B6: rectangular wave signal
- When the rpm sensor N3 detects 0 rpm of planetary gear carrier speed.
- Check the related harness for open, short and contact.
• TCU connector terminal B6: rectangular wave signal
- When the rpm difference between rpm sensor N2 and N3 is over
150 rpm.
- Check the related harness for open, short and contact.
- Turn the IGN OFF, then disconnect TCU connector.
- Selector lever position: R or D
- Measure the resistance of oil temperature sensor.
• TCU connector terminals: B7, B8
- Check the related harness for open, short and contact.
- Turn the IGN OFF, then disconnect TCU connector.
- Selector lever position: R or D
- Measure the resistance of oil temperature sensor.
• TCU connector terminals: B7, B8
- Check the related harness for open, short and contact.
- Turn the IGN OFF, then disconnect TCU connector.
- Selector lever position: R or D
- Measure the resistance of oil temperature sensor.
• TCU connector terminals: B7, B8
- Check the related harness for open, short and contact.
- Turn the IGN OFF, then disconnect TCU connector.
- Check the communication line for open, short and contact.
- Measure the resistance of CAN line: B1, B2
• Specified value: approx. 120 Ω
Action
B8: signal ground
B13: 6V
B8: signal ground
B13: 6V
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
3A1-57