SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 946

2) Install the washer and hub nut. Caulk the nut end to
lock the nut. After caulking, apply grease or paint
on the caulked area.
Tightening torque
3) Install the brake disc and brake caliper.
6. With part time transfer case
1) Tighten the hub nut with special tool.
Tightening torque
2) Separate the vacuum hose for auto locking hub from
steering knuckle.
3) Remove the screws and pull out the locking plate.
Notice
Make sure to check the O-ring for wear and damage.
4) Adjust the clearance between snap ring and hub
cover with appropriate shims so that it is below
0.2 mm.
Shims
Max. clearance
5) Install the hub cover.
Tightening torque
Note
The washer cams should be engaged each other.
FRONT AXLE
REXTON SM - 2004.4
250 ~ 350 Nm
15 Nm
0.2, 0.3, 0.5, 1.0 mm
below 0.2 mm
50 ~ 60 Nm
4A-11
Y220_04A020
Y220_04A021
Y220_04A022
Y220_04A023
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN