Tread; Tire Wear; Tire Inflation Pressure - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

GENERAL INSPECTION

Tread

Inspect the tread condition on the tire surface and various
damages resulting from the foreign material, crack, stone or
nail etc. If there is any damage in the tire, repair or replace it.

Tire Wear

• Measure the depth of the tire tread. If the depth of the tread
is below the specified value, replace the tire.
Limit of the Tread Wear
• You can see the mark ' ' in the groove, this is the indicator
of the tread wear limit.
• The limit of the tread wear for all season tires are 1.6 mm
as same as the general tires and the platform mark
indicates as ' '.

Tire Inflation Pressure

1. Inflation pressure
Front / Rear
2. Inspect the pressure of the tire surface and check the
inflation pressure.
Notice
• Lower than recommended pressure can cause tire
squeal on turns, hard steering, tire cord breakage
and tire rim bruises, etc.
• Higher than recommended pressure can cause hard
ride, tire bruising or damage and rapid tread wear
at the center of the tire.
WHEELS & TIRE
REXTON SM - 2004.4
1.6 mm
2
2.1 kg/cm (30 psi)
Sufficient Insufficient
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
5A-17
Y220_05A041
Y220_05A042
Excessive
Y220_05A043