SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 723

3A2-174
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
4. Install the rear servo lever and pivot pin.
Notice
The lever must pivot freely on its pin.
Y220_3A2890
5. Assemble the park rod lever, complete with the return
spring and pivot pin, applying a small amount of sealant
to the outer end of the pivot pin.
Notice
Care must be taken when applying sealant to ensure
that it is not applied between the pin and the lever.
6. Secure the pivot pin with the circlip.
Notice
The lever must pivot freely on its pin and the spring
must return the park rod lever to its correct location.
Y220_3A2640
7. Install the parking pawl pivot pin and spring.
Notice
The pawl must pivot freely on its pin.
Y220_3A2900
8. Connect the park rod to the manual valve detent lever.
Ensure the spring and cam collar is firmly installed on
the rod.
9. Check that the cam collar slides freely on the rod.
10. Insert the cross shaft into the case, from the side
opposite to the inhibitor switch, then install the antirattle
spring on the shaft.
Y220_3A2910
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4