Forward Clutch Cylinder - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

18. To remove the park rod lever: Remove the circlip from the
inner end of the pivot shaft and tap the outer end of the
shaft until it moves free from the case, then using a wide
shallow tapered drift as a wedge, drive the pin out from
the inside of the case and remove the lever and spring.
Notice
Do not remove the park rod lever unless absolutely
necessary.

Forward Clutch Cylinder

Tools Required
0555-336259 Clutch Spring Compressor
1. Place the assembly in a horizontal position.
2. Remove the No. 4 needle bearing (2) and adjust-ment
shims (1) from the input shaft.
3. Remove the circlip from the front of the clutch cylinder
and remove the input shaft.
4. Remove the overdrive shaft and the C1 clutch hub
assembly from the clutch cylinder.
5. Remove the C1 clutch plates from the cylinder.
6. Remove the circlip retaining the C3 clutch hub in the rear
of the clutch cylinder and remove the hub.
7. Remove the C2/C4 clutch hub assembly and remove the
No. 5 needle bearing from the C4 hub.
8. Removethe C2 clutch plates.
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4
3A2-167
Y220_3A2640
Y220_3A2650
Y220_3A2660
Y220_3A2670
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN